Does ATTO bridge request to restart/reboot after change management IP address ?
Applies to
ATTO FibreBridge
Answer
Yes, after configure or modify ATTO management IP address, you must run the commands"SaveConfiguration
" and you are prompted to restart the bridge to put the new configuration into effect.
Note:To set the IP address without the QuickNAV utility, you need to have a serial connection to the FibreBridge.
Example:
If using the CLI, you must run the following commands:
set ipaddress mp1 ip-address
set ipsubnetmask mp1 subnet-mask
set ipgateway mp1 x.x.x.x
set ipdhcp mp1 disabled
set ethernetspeed mp1 1000
SaveConfiguration
You are prompted to restart the bridge.
Additional Information