Skip to main content
NetApp Knowledge Base

Does ATTO FibreBridge request restart after change password ?

  1. Last updated
  2. Save as PDF
Views:
191
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
metrocluster
Last Updated:

Applies to

ATTO FibreBridge

Answer

Yes, after configure or modify ATTO FibreBridge password, you must run the command "SaveConfiguration" to make it persistent across reboots and you need restart the bridge to put new configuration take effect.

Additional Information

ATTO FibreBridge Installation and Operation Manual

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.