Skip to main content
NetApp Knowledge Base

What port does ONTAP use to send AutoSupports?

  1. Last updated
  2. Save as PDF
Views:
99
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
core
Last Updated:

Applies to

  • ONTAP 9
  • AutoSupport

Answer

  • ONTAP sends AutoSupports out ports that are configured with the management-autosupport service.
  • By default this is e0M.
  • You can verify what LIF/port has the service with the following command:

cluster1::> network interface show -services management-autosupport
            Logical    Status     Network            Current       Current Is
Vserver     Interface  Admin/Oper Address/Mask       Node          Port    Home
----------- ---------- ---------- ------------------ ------------- ------- ----
cluster1
            cluster1-01_mgmt1
                         up/up    192.168.0.111/24   cluster1-01   e0M     true
            cluster1-02_mgmt1
                         up/up    192.168.0.112/24   cluster1-02   e0M     true
            cluster_mgmt up/up    192.168.0.101/24   cluster1-01   e0M     true
3 entries were displayed.

Additional Information

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.