ONTAP upgrade task aborted with error: failed to set field "vserver" to "x"
Applies to
- ONTAP 9
- ONTAP upgrade
Issue
- System shows following message after ONTAP upgrade attempt:
The upgrade is not complete: an upgrade task aborted. This node is not fully operational. Contact support personnel for the upgrade repair procedure.
- Upgrade Task aborted due to "failed to set field "vserver" to "3""
cluster1::*> system node upgrade-revert show
Node: cluster1-n1 Status: aborted
Status Message: The upgrade aborted. Contact support personnel for the upgrade repair procedure.
Vers Phase Status Upgrade Phase Status Message
---- ---------- -------- ------------------------------------------------------
700 pre-root applied No upgrade is required for this phase.
700 pre-apps applied Upgrade successful.
700 post-apps aborted failed to set field "vserver" to "3"
(...)
- There is no SVM with the name "3"
cluster1::*> vserver show -vserver 3
Error: Vserver name: Invalid. The Vserver name must begin with a letter or an underscore. Maximum supported length:
41 if Vserver is type "sync-source", 47 otherwise.
- Error when checking -instance output:
Status Message: The upgrade failed in the "post-apps" phase on task " OpenSSH 8.1 Upgrade/Revert Task".