Skip to main content
NetApp Knowledge Base

How to replace a file system partition with a spare partition

  1. Last updated
  2. Save as PDF
Views:
2,572
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
CORE
Last Updated:

Applies to

Description

This article describes the procedure that should be followed to perform Rapid RAID Recovery to copy data from one specified file system partition to a spare partition.

  • The storage disk partition replace command starts or stops the replacement of a file system partition with spare partition.
  • When you start a replacement, Rapid RAID Recovery begins copying data from the specified file system partition to a spare partition.
  • When the process is complete, the spare partition becomes the active file system partition and the file system partition becomes a spare partition.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.