Skip to main content
NetApp Knowledge Base

How to modify flow control on cluster port in ONTAP

  1. Last updated
  2. Save as PDF
Views:
4,551
Visibility:
Public
Votes:
3
Category:
ontap-9
Specialty:
CORE
Last Updated:

​

​

Applies to

  • ONTAP 9
  • NetApp cluster network interface

Description

  • The NetApp Best Practice specifies that Flow Control settings for 10GbE cluster ports are to be set with Flow Control = None
  • This article provides an example of how to modify these settings non-disruptively in the event that these were not set correctly
  • This article does not apply to 100GbE cluster ports using RDMA for cluster interconnect

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.