Skip to main content
NetApp Knowledge Base

system health alert reports "PSU State: failed" error

  1. Last updated
  2. Save as PDF
Views:
43
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

Shelf DS212-12

Issue

  • Node reports PSU State: failed in health alerts:

::> system health alert show
    Node: ****
           Resource: Shelf UUID: ****
           Severity: Major
    Indication Time: ****
           Suppress: false
        Acknowledge: false
     Probable Cause: Power Supply Units (PSU) on Shelf 2.12 connected to controllers **** are not operational.
                     PSU ID: 2. PSU State: failed.
    Possible Effect: Some SAS or NVMe storage shelves might not be accessible.
 Corrective Actions: 1. Check the AC power distribution to the PSU and the PSU power switch.
                     2. Switch off the PSU (if equipped). Remove the PSU.
              Wait one minute. Insert the PSU. Switch on the PSU (if equipped).
Request Failure Analysis: No

  • Swap the PSU to another shelf, and the alert source will move along with the PSU.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.