Skip to main content
NetApp Knowledge Base

Why does 'disk show -ssd-wear' show 0 percent

  1. Last updated
    May 19, 2022
  2. Save as PDF
Views:
723
Visibility:
Public
Votes:
0
Category:
aff-series
Specialty:
hw
Last Updated:
5/19/2022, 7:59:52 AM

Applies to

SSD disks

Answer

On large capacity SSDs the ssd wear values show 0% because the number of spare blocks consumed is much less than <1% so shows as 0.

Additional Information

N/A

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.