Skip to main content
NetApp Knowledge Base

Undertemp alerts after upgrading BMC firmware to 11.10

  1. Last updated
  2. Save as PDF
Views:
773
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • AFF A220, AFF A150, AFF C190, ASA A150, FAS2720, FAS2750
  • ONTAP 9
  • BMC firmware 11.10

Issue

  • Following upgrading BMC firmware to 11.10, sporadic undertemp alert seen by both nodes.
  • Alerts clear shortly after being triggered

Example:

[NODE-02: dsa_worker4: ses.status.temperatureWarning:alert]: DS212-12 (S/N SHJGD23189XXXXX) shelf 0 on channel 0a temperature warning for Temperature sensor 11: non-critical status; undertemperature warning. Current temperature: 0 C (32 F). This module is on the rear of the shelf at the top left, on shelf module A.

[NODE-02: dsa_worker4: ses.status.temperatureInfo:info]: DS212-12 (S/N SHJGD23189XXXXX) shelf 0 on channel 0a temperature information for Temperature sensor 11: normal status.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.