Skip to main content
NetApp Knowledge Base

Unable to configure e0c and e0d ports as storage in maintenance mode

  1. Last updated
  2. Save as PDF
Views:
909
Visibility:
Public
Votes:
1
Category:
aff-series
Specialty:
HW
Last Updated:

Applies to

  • AFF A400
  • All ONTAP version
  • NS224 disk shelf
  • New installation

Issue

  • When trying to set ports e0c/e0d as storage in maintenance mode, the following error is displayed
*> storage port modify -p e0c -m storage
sysctl failed cmd_storage_port_mode_storage 8238. Return code = 2
*> storage port modify -p e0d -m storage
sysctl failed cmd_storage_port_mode_storage 8238. Return code = 2
  • Ports do not change mode
*> storage port show
Port Type Mode    Speed(Gb/s) State    Status  VLAN ID
---- ---- ------- ----------- -------- ------- -------
e0c  ENET network -           -        -       0
e0d  ENET network -           -        -       0

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.