Skip to main content
NetApp Knowledge Base

SP show command indicates special characters after IP address

  1. Last updated
    Mar 17, 2025
  2. Save as PDF
Views:
20
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:
3/17/2025, 10:55:34 AM

Applies to

  • AFF C250
  • BMC 15.11

Issue

SP show command indicated special characters after IP addresses.

Cluster::> sp show
                                  IP        Firmware
Node          Type Status      Configured   Version   IP Address
------------- ---- ----------- ------------ --------- -------------------------
node_name_01  BMC  online      true         15.11     xx.xx.xx.xx
node_name_02  BMC  online      true         15.11     xx.xx.xx.xx, ::   <--------
2 entries were displayed.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.