Skip to main content
NetApp Knowledge Base

SFP AFBR-710DMZ-IN1 can not visiable

  1. Last updated
  2. Save as PDF
Views:
210
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • X1147A
  • AFBR-710DMZ-IN1
  • FAS8300

Issue

From sysconfig -a SFP AFBR-710DMZ-IN1 can't visiable in X1147A Card if not connect cable.
below example insert SFP in e4b/e4c/e4d port but not connect cable.
 
Sysconfig -a output:
slot 4: Quad 10 Gigabit Ethernet Controller X710 SFP+
e4a MAC Address:    40:a6:b7:a5:60:18 (auto-10g_sr-fd-up)
SFP Vendor:         Intel Corp
SFP Part Number:    AFBR-710DMZ-IN1
SFP Serial Number:  AC2210P034P
e4b MAC Address:    40:a6:b7:a5:60:19 (auto-unknown-fd-down)
SFP Vendor:
SFP Part Number:
SFP Serial Number:
e4c MAC Address:    40:a6:b7:a5:60:1a (auto-unknown-fd-down)
SFP Vendor:
SFP Part Number:
SFP Serial Number:
e4d MAC Address:    40:a6:b7:a5:60:1b (auto-unknown-fd-down)
SFP Vendor:
SFP Part Number:
SFP Serial Number:

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.