Skip to main content
NetApp Knowledge Base

PSU sensor show NOT_PRESENT

  1. Last updated
  2. Save as PDF
Views:
247
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
hw
Last Updated:

Applies to

  • ONTAP 9
  • FAS2750

Issue

  • PSU sensor show NOT_PRESENT or unreachable in following command.
 
::> system chassis fru show
　
　Chassis ID         FRU       Type    State      Nodes Sharing the FRU
　------------------- ---------- -------- ----------- -----------------------
　111111111111       PSU2 FRU  psu     GOOD       node1, node2
　111111111111       PSU1 FRU  psu NOT_PRESENT node2
 
::> system controller fru show
Node               FRU Name                     Subsystem          Status
------------------ ---------------------------- ------------------ -----------
node1          PSU1 FRU                     Environment        unreachable
  • BMC log show PSU as normal and PSU actually working normally.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.