Skip to main content
NetApp Knowledge Base

ONTAP drive failed with "Failed-Unsupported" status - Resolution Guide

Views:
5,665
Visibility:
Public
Votes:
3
Category:
disk-drives
Specialty:
HW
Last Updated:

Applies to

  • ONTAP 9
  • AFF systems
  • FAS systems
  • Drives

Description

Follow this guide to help you locate the proper solution to your question or issue

Cluster::> system node run -node <node name> -command sysconfig -a

07.0 : 0.0GB 0B/sect (Failed-Unsupported)
07.1 : 0.0GB 0B/sect (Failed-Unsupported)
07.2 : 0.0GB 0B/sect (Failed-Unsupported)
  • EMS Messages such as the below can be observed on the system:

::>Event log show

Sun Nov 22 12:07:42 +0100 [node-01: scsi_cmdblk_strthr_admin: scsi.cmd.pastTimeToLive:error]: Disk device 0a.07.0: request failed after try #1: cdb 0x12. 
Sun Nov 22 12:07:42 +0100 [node-01: scsi_cmdblk_strthr_admin: disk.init.err.unsupported:error]: Disk 0b.07.0 is not recognized as a supported disk and cannot be used on this node.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.