Skip to main content
NetApp Knowledge Base

Node stuck at 'BIOS image updated, resetting to load defaults' during ONTAP upgrade

  1. Last updated
  2. Save as PDF
Views:
1,014
Visibility:
Public
Votes:
1
Category:
fas-systems
Specialty:
HW
Last Updated:

Applies to

  • FAS8200
  • FAS2720
  • Automated non-disruptive upgrade (ANDU) from 9.5P9 to 9.7P7

Issue

  • Node gets stuck during the update with message and does not continue
 
BIOS image updated, resetting to load defaults
 
  • ONTAP update status is paused
 
SP event logs show node experienced a L2 watchdog reset
 
[SysFW.notice]: Updating flash. Current BIOS version: 11.1
[SysFW.notice]: New BIOS version: 11.4
[IPMI.notice]: 3f01 | 02 | EVT: 0301ffff | CPU0_Error | Assertion Event, "State Asserted"
[IPMI Event.critical]: L2 watchdog timeout power cycle
[IPMI.notice]: 4001 | 02 | EVT: 6fc302ff | System_Watchdog | Assertion Event, "Power cycle"
[IPMI Event.critical]: L2 watchdog action completed
[SP.notice]: Delaying L2_WDOG ASUP email for 120 seconds
[IPMI.notice]: 4101 | 02 | EVT: 6fc100ff | System_FW_Status | Assertion Event, "Unspecified"
 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.