Skip to main content
NetApp Knowledge Base

Network Interface card X91440A reports: Card in slot N is not supported

  1. Last updated
  2. Save as PDF
Views:
646
Visibility:
Public
Votes:
0
Category:
aff-series
Specialty:
HW
Last Updated:

Applies to

  • ONTAP 9
  • AFF-A700
  • FAS9000
  • AFF-A900
  • FAS9500
  • Network Interface Card X91440A

Issue

::> run -node <node_name| local> -command sysconfig -ac

sysconfig: Card in slot 5 (0-8086-154B-0) is not supported.


slot 5: 10/40 Gigabit Ethernet Controller XL710 QSFP+
e5a MAC Address: d0:39:ea:41:d9:57 (auto-40g_cr4-fd-up)
QSFP Vendor: CISCO-JPC
QSFP Part Number: P3007U305000-1
QSFP Serial Number: JPC#####5BV-B
Device Type: XL710 B1
Firmware Version: fw 5.20 nvm 5.04 etid 800045ac
Part Number: 111-02590
Hardware Revision: B0
Serial Number: 0######1

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.