Skip to main content
NetApp Knowledge Base

LACP ifgroup ports are stuck down following ONTAP upgrade

Views:
701
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
HW
Last Updated:

Applies to

  • FAS/AFF
  • ONTAP 9
  • Data ports in an ifgroup using LACP

Issue

  • Following the ONTAP upgrade and giveback, two of the data ports in an ifgroup are stuck in the down state
  • Bouncing the ports on the node and the switch, removing and re configuring the LACP on the switch and performing TO/GB of the node with the issue yields no results
  • The switch reports:
Feb 3 10:27:57.950: %switch: Gi1/0/18 suspended: LACP currently not enabled on the remote port.
Feb 3 10:27:58.738: %switch: Gi1/0/17 suspended: LACP currently not enabled on the remote port.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.