Skip to main content
NetApp Knowledge Base

How to wipe the SP/BMC

  1. Last updated
  2. Save as PDF
Views:
2,662
Visibility:
Public
Votes:
1
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

Description

The following procedure will completely wipe out all the configuration and logs of the SP / BMC

  • If currently connected through the SP/BMC IP address, connectivity will be lost after completing these steps
  • If cluster management or node management are reachable the IP address for the SP/BMC can be setup following the steps; otherwise, it is suggested to login via a local console cable


Note: Make sure to review How to decommission or repurpose an HA Pair with ONTAP 9 

  • If node and cluster initialization is not performed before, the SP/BMC configuration will be temporarily removed. The config will re-sync with ONTAP.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.