Skip to main content
NetApp Knowledge Base

How to set environment variables during a boot device replacement

  1. Last updated
    Oct 24, 2024
  2. Save as PDF
Views:
3,471
Visibility:
Public
Votes:
1
Category:
fas-systems
Specialty:
hw
Last Updated:
10/24/2024, 8:27:07 PM

Applies to

  • AFF Models
  • FAS Models
  • ONTAP 9.3+

Description

  • During a boot device replacement certain environment variables might be required to be manually set.
  • Each of the procedures for boot device replacement include a step detailing using the setenv LOADER command to manaully set variables.
  • An environment variable might also be referred to as a bootarg.
  • This procedure applies to ONTAP 9.3 and newer only.

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.