Skip to main content
NetApp Knowledge Base

How to perform a Baseboard Management Controller (BMC) network setup from LOADER prompt

  1. Last updated
  2. Save as PDF
Views:
8,770
Visibility:
Public
Votes:
5
Category:
aff-series
Specialty:
hw
Last Updated:

Applies to

Description

How to perform a Baseboard Management Controller (BMC) network setup from the LOADER prompt on AFF and FAS platforms.

Manual configuration of the BMC from the LOADER prompt is only performed under a limited set of circumstances. The recommended method of configuring the BMC is in ONTAP by using the system service-processor network modify clustershell command.

Note that any BMC network configuration changes made at the LOADER prompt will be overwritten (resynced) by ONTAP using any saved configuration shortly after ONTAP boots up.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.