Skip to main content
NetApp Knowledge Base

FAS2554 attention LED ON

  1. Last updated
  2. Save as PDF
Views:
576
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • FAS2554
  • Data ONTAP operating in 7-Mode
  • Service Processor (SP) firmware  2.2.5P2

Issue

  • Controller attention LED ON
  • ONTAP command storage show fault -v report status normal but all PSU with DC UNDER VOLTAGE

node_name> storage show fault -v

Enclosure Status: normal
Channel: 0a
Shelf: 0
Shelf Type: DS4246
Product Serial Number: serial_number
Module Type: IOM6E

Power Supplies:
Element Status         Status Bytes  Status Descriptions
  1: OK                01,00,04,A0   DC UNDER VOLTAGE, RQSTED ON
  2: OK                01,00,04,A0   DC UNDER VOLTAGE, RQSTED ON
  3: OK                01,00,04,A0   DC UNDER VOLTAGE, RQSTED ON
  4: OK                01,00,04,A0   DC UNDER VOLTAGE, RQSTED ON

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.