Skip to main content
NetApp Knowledge Base

Disk shows in broken pool even after replacement

  1. Last updated
  2. Save as PDF
Views:
1,837
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

​ ​

Applies to

Data ONTAP 8.2.1

Issue

Command "sysconfig -r" displays the old failed disk even the disk has been replaced like below.

Example:

Broken disks

RAID Disk Device   HA  SHELF BAY CHAN Pool Type  RPM  Used (MB/blks)    Phys (MB/blks)
--------- ------   ------------- ---- ---- ---- ----- --------------    --------------
failed   0a.02.14 0a    2   14  SA:A   0   SAS 15000 560000/1146880000 560208/1147307688

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.