Skip to main content
NetApp Knowledge Base

Disk copy can't start when a disk failure

  1. Last updated
    Jan 20, 2021
  2. Save as PDF
Views:
425
Visibility:
Public
Votes:
0
Category:
clustered-data-ontap-8
Specialty:
hw
Last Updated:
1/20/2021, 1:28:43 AM

Applies to

Clustered  Data ONTAP 8.x

Issue

Although there is a spare disk, the disk copy cannot start when the disk fails.
And the following message is output.
 
[?] Sun Dec 27 18:40:19 JST [cluster1-01: config_thread: raid.rg.diskcopy.cant.start:notice]: /aggr0/plex0/rg0: unable to start disk copy for 0a.00.3P2: Long running operations limit reached.
 
Later, the disk copy starts automatically.

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.