Skip to main content
NetApp Knowledge Base

After reboot node is down, SP accessible but no console output due to power

  1. Last updated
  2. Save as PDF
Views:
866
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
HW
Last Updated:

Applies to

  • ONTAP 9
  • AFF Systems
  • FAS Systems

Issue

  • Node was rebooted for maintence and then unable to boot back up.
  • When connected via console cable SP is accessible and system power status is off. When turned on and moved to the console output the node shows the copyright message then stops. 
  • If system power status is checked again it reports as off. 
    SP> System power status
Power status: off
SP> system power on
SP> system console

Copyright 2021 American Megatrends, Inc.

(CTRL + D to flip back to SP)
SP> System power status
Power status: off

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.