Skip to main content
NetApp Knowledge Base

BMC does not boot with the primary firmware version after upgrade

  1. Last updated
  2. Save as PDF
Views:
106
Visibility:
Public
Votes:
0
Category:
not set
Specialty:
not set
Last Updated:

Applies to

  • AFF-C800
  • ONTAP 9
  • Baseboard Management Controller (BMC)

Issue

  • BMC does not boot with Primary firmware version 10.9P2
  • Although the primary firmware has been successfully upgraded, the booted version still shows the old version.

BMC cluster1> version
Booted primary firmware version 10.9P1
Primary firmware version 10.9P2
Backup firmware version 10.9P1

  • Multiple reboots and attempts to boot from Primary firmware version 10.9P2 were unsuccessful

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.