Skip to main content
NetApp Knowledge Base

MDV_CRS Volume can not be moved from SnapLock aggregate

  1. Last updated
  2. Save as PDF
Views:
334
Visibility:
Public
Votes:
0
Category:
snapmirror
Specialty:
dp
Last Updated:

Applies to

  • ONTAP 9.x
  • SVM DR
  • SnapLock

Issue

  • Volume move of the MDV_CRS volume from an SnapLock aggregate fails:
cluster1::*> vol move start -volume MDV_CRS_xxx -destination-aggregate aggr1 -vserver cluster
Warning: You are about to modify the system volume "MDV_CRS_xxx". This might cause severe performance or stability problems. Do not proceed unless directed to do so by support. 
Do you want to proceed? {y|n}: y
Error: command failed: Unable to move volume "MDV_CRS_xxx" in Vserver "cluster". Audit log volume must be configured for the Vserver
  • Customer does not want to provision a SnapLock audit volume for the cluster admin vserver
 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.