Skip to main content
NetApp Knowledge Base

Low Rx power reported on Brocade switch port due to faulty SFP on upstream device

Views:
1,762
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
brocade
Last Updated:

Applies to

Brocade Switch

Issue

  • sfpshow reports Rx value is too low

Slot  5/Port 21:
=============
Identifier:  3    SFP
Connector:   7    LC
Transceiver: 6804404000000000 8,16,32_Gbps M5 sw Short_dist
[...]
Vendor Name: BROCADE
Vendor OUI:  00:05:1e
Vendor PN:   57-1000333-01
Vendor Rev:  A
[...]
Temperature: 59      Centigrade
Current:     7.640   mAmps
Voltage:     3327.1  mVolts
RX Power:    -25.1   dBm (3.1  uW)
TX Power:    -1.3    dBm (743.9 uW)

Note : The upstream/end device can be storage or host, check the adapter values on storage or host and proceed further with the solution.

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.