Skip to main content
NetApp Knowledge Base

Brocade G720 and G610 switch fails to power on post power maintenance activity

  1. Last updated
  2. Save as PDF
Views:
218
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
brocade
Last Updated:

Applies to

  • Brocade G720
  • Brocade G610

Issue

  • Brocade G720 and G610 switch not powering on.
  • The LEDs on the switch blinks for a brief period and then stopped blinking completely.
  • Connecting the switch serially does not display any output and there is no led blinking either on the console port.
  • No blinking LED at all on any of the ports on the switch end.
  •  Below steps can be performed:
    • Connect the switch serially and power cycle the switch
    • Swap the power cables with good known power cable
    • Connect the power cables to a different PDU
    • Check if there are any LED blinking
  • If above steps doesn't help , proceed to the "solution" section

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.