Skip to main content
NetApp Knowledge Base

Switch accessibility lost after FOS upgrade from v9.1.1c3 to v9.2.1a

  1. Last updated
  2. Save as PDF
Views:
32
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
brocade
Last Updated:

Applies to

Brocade switch Upgrade

Issue

  • Switch accessibility lost after FOS upgrade from v9.1.1c3 to v9.2.0b.
  • After the 9.2.0b firmware loaded to the standby CP, the CP went for reboot came up clean and took over as active. This is all normal for firmware upgrades.
  • After it became active and reboot the previously active CP, the NPD deamon terminated causing the new active CP to reboot to recover and the system recovered with CP 0 as active still on the 9.1.1c3 code.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.