Skip to main content
NetApp Knowledge Base

What Firewall Port does SANtricity use?

  1. Last updated
  2. Save as PDF
Views:
866
Visibility:
Public
Votes:
1
Category:
e-series-systems
Specialty:
esg
Last Updated:

​ ​ ​  

Applies to

E-Series Controller Firmware 7.xx

Answer

When configuring a firewall to use SANtricity on the outside of the network on which the storage system is, the TCP port 2463 should be opened.

On the client-end of the connection, the port can be any, which is greater than 1023.

AutoSupport in 07.86 and later will use the same port, so no other port needs to be opened.

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.