Skip to main content
NetApp Knowledge Base

What AutoSupport IP/FQDN settings to use when configuring a firewall?

  1. Last updated
  2. Save as PDF
Views:
1,121
Visibility:
Public
Votes:
2
Category:
storagegrid
Specialty:
sgrid
Last Updated:

 

Applies to

NetApp StorageGRID

Answer

When configuring a network firewall, use domain support.netapp.com for setting up the rule. When an IPv4 address is needed use nslookup support.netapp.com to determine the IPv4 address.

Example:

nslookup support.netapp.com
Server:  ns35.europe.netapp.com
Address:  10.64.2.88

Name:    support-hio.netapp.com
Addresses:  2620:10a:4005:c000::a78:2d11
          216.240.21.18
Aliases:  support.netapp.com

Additional Information

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.