Skip to main content
NetApp Knowledge Base

How to set up NTP time synchronization in Data ONTAP 7-Mode

  1. Last updated
  2. Save as PDF
Views:
5,498
Visibility:
Public
Votes:
0
Category:
data-ontap-7
Specialty:
7dot
Last Updated:

Applies to

Data ONTAP 7 and earlier

Description

This article describes the procedure on how to set up NTP time synchronization in Data ONTAP 7-Mode and to configure SNTP.

To configure SNTP, perform the step below :

  1. Set up SNTP (Simple Network Time Protocol)

Notes:

  • Reminder: you should also set option timed.servers on the partner node or the next takeover might not function correctly. Change the timed.servers option which applies to both members of the cluster in takeover mode. This value must be the same in both cluster members earlier than any takeover or giveback, or that next takeover/giveback might not work correctly.
  • Option timed.servers changed on one cluster node.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.