Skip to main content
NetApp Knowledge Base

hardwareConfigMismatch alerts after adding new nodes to the cluster

  1. Last updated
  2. Save as PDF
Views:
540
Visibility:
Public
Votes:
0
Category:
netapp-hci
Specialty:
hci
Last Updated:

Applies to

  • NetApp HCI
  • NetApp H610S storage nodes

Issue

  • Network firmware version and BIOS settings alerts are triggered after adding a node to a cluster
  • NetApp SolidFire Active IQ reports the following alerts:
    • NETWORK_FIRMWARE_VERSION_ETH0 should be == 14.22.1002 (MT_2420110034) but is 14.25.1020 (MT_2420110034)
    • NETWORK_FIRMWARE_VERSION_ETH1 should be == 14.22.1002 (MT_2420110034) but is 14.25.1020 (MT_2420110034)
    • Incorrect bios setting "allow_correctables" should be == enable but is null
  • Error code:
    • hardwareConfigMismatch

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.