Skip to main content
NetApp Knowledge Base

'TCAM region is not configured' seen Cisco 3132Q when applying RCF 1.8 or later

  1. Last updated
  2. Save as PDF
Views:
418
Visibility:
Public
Votes:
2
Category:
fabric-interconnect-and-management-switches
Specialty:
hw
Last Updated:

Applies to

  • Cisco 3132Q Cluster switch
  • RCF 1.8 and later

WARNING

Article doesn't apply to MetroCluster IP configurations

Issue

  • When applying the 1.8 RCF (or later) to cluster switch the following alert is seen,
Unable to perform the action due to incompatibility:  Module 1 returned status "TCAM region is
not configured. Please configure TCAM region and retry the command"

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.