Skip to main content
NetApp Knowledge Base

Cisco 3132Q-V RCF 1.6 causes TCAM region is not configured error and blocks 10GbE connectivity

  1. Last updated
  2. Save as PDF
Views:
515
Visibility:
Public
Votes:
0
Category:
fabric-interconnect-and-management-switches
Specialty:
hw
Last Updated:

Applies to

  • Cisco Nexus 3132Q-V
  • RCF 1.6

Issue

  • RCF 1.6 installation issue:
2021 Mar 18 16:35:19 NetApp_CLS_SW-A %$ VDC-1 %$ %ACLQOS-SLOT1-2-ACLQOS_FAILED: ACLQOS failure: TCAM region is not configured for feature QoS class IPv4 direction ingress. Please configure TCAM region IPV4 Port QoS [qos] and retry the command.
 
  • While attempting to utilize the 10GbE breakout ports, the cluster ports are non-functional

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.