Skip to main content
NetApp Knowledge Base

Cannot apply RCF after upgrading to NXOS 9.3(6) - 9.3(8)

  1. Last updated
  2. Save as PDF
Views:
3,447
Visibility:
Public
Votes:
2
Category:
fabric-interconnect-and-management-switches
Specialty:
hw
Last Updated:

Applies to

  • Cisco Nexus 3132Q-V cluster switches
  • NXOS 9.3(6) - 9.3(8)

Issue

After upgrading the Cisco Nexus 3132Q-V cluster switch to NXOS version 9.3(6) - 9.3(8), applying the RCF fails:

switch# conf term
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# policy-map type queuing SampleMap
Invalid class referenced

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.