Skip to main content
NetApp Knowledge Base

When does the NVRAM Destage status LED turn on?

  1. Last updated
  2. Save as PDF
Views:
464
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • FAS9000
  • ONTAP 9

Answer

The behavior of the DCPM (Destage Control Power Module) Destage status LED is as follows.

  • The LED is blinking when destage is running
  • The LED light on when destage is complete and the system is loader status
  • The LED turn off when destage is completed and the system is running

Additional Information

Destage is performed at the following timing

  • Initial boot-up
  • The weekly silent destage/restage test
  • Trigger AC power off

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.