Skip to main content
NetApp Knowledge Base

Disabling IPv4/IPv6 IP for BMC not working from ONTAP and shows error

  1. Last updated
  2. Save as PDF
Views:
372
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • AFF A400
  • FAS8700
  • FAS8300

Issue

Disabling IPv4/IPv6 of BMC from ONTAP not working and shows error to enable IPv6/IPv4, even though both IPv4 and IPv6 are enabled.

::> sp network modify -node node1 -address-family IPv4 -enable false

Error: command failed: IPv4 address can be disabled only if IPv6 address is enabled.

::> sp network modify -node node1 -address-family IPv6 -enable false

Error: command failed: IPv6 address can be disabled only if IPv4 address is enabled.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.

 

  1. Back to top
  • Was this article helpful?

Recommended articles

  1. Article type
    Reference
    KCS Candidate/Contributor Workflow
    Published
    Confidence
    Validated
    Flag
    False
    Governance
    Experience
    KCS Enabled
    Yes
    Visibility
    Public
    Product Categories
    FAS Systems
    Specialty
    HW
  2. Tags
    1. 2008928875