Skip to main content
NetApp Knowledge Base

Both PSUs showing fault

Views:
109
Visibility:
Public
Votes:
1
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

FAS2750

Issue

  • Two PSUs of single node show fault:
Example:
Sensor Name              State          Current    Critical     Warning     Warning    Critical
                                        Reading       Low         Low         High       High
-------------------------------------------------------------------------------------------------
PSU2 FRU                                MULTIFAULT
PSU1 FRU                                MULTIFAULT
SP Status                               IPMI_HB_OK
mSATA Status                                OK
mSATA Pres                              PRESENT
  • The PSUs of partner node which uses the same PSUs are good:
Example:
Sensor Name              State          Current    Critical     Warning     Warning    Critical
                                        Reading       Low         Low         High       High
-------------------------------------------------------------------------------------------------
PSU2 FRU                                  GOOD
PSU1 FRU                                  GOOD
SP Status                               IPMI_HB_OK
mSATA Status                                OK
mSATA Pres                              PRESENT
 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

Scan to view the article on your device

 

  • Was this article helpful?