Skip to main content
NetApp Knowledge Base

Unable to add switches to Cluster Switch Health Monitor (CSHM) when IPv6 is used

  1. Last updated
  2. Save as PDF
Views:
295
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
core
Last Updated:

Applies to

  • All ONTAP releases
  • All Cluster Network switches
  • IPv6

Issue

  • When only IPv6 is used for ONTAP and Cluster Network switches management, switches fail to be automatically added to CSHM
  • Adding switches manually to CSHM via system cluster-switch create reports error
Error: command failed: Monitoring is not supported for IP addresses in the address family "ipv6"

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.