Skip to main content
NetApp Knowledge Base

How to setup or modify AutoSupport in Clustered Data ONTAP 8

  1. Last updated
  2. Save as PDF
Views:
835
Visibility:
Public
Votes:
0
Category:
clustered-data-ontap-8
Specialty:
core
Last Updated:

Applies to

  • Clustered Data ONTAP 8
  • AutoSupport

Description

This article describes the procedure to set up the AutoSupport feature on your Clustered Data ONTAP 8 storage system.

  • By default, AutoSupport is enabled on each node to send messages to NetApp Support by using the HTTPS transport protocol.
  • You can control whether and how AutoSupport information is sent to NetApp Support and your internal support organization, and then test that the configuration is correct.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.