Skip to main content
NetApp Knowledge Base

NetApp HCI compute node does not boot to ESXi automatically

Views:
409
Visibility:
Public
Votes:
0
Category:
netapp-hci
Specialty:
solidfire
Last Updated:

Applies to

NetApp HCI compute nodes

Issue

The NetApp HCI compute node will not boot to ESXi automatically, or will require intervention with keyboard input to continue booting with below shown at the console:

Port <#>: INTEL SSDSCKJB240G7
S.M.A.R.T Status Bad, Backup and Replace
Press F1 to Resume...

Capture.PNG

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device