Skip to main content
NetApp Knowledge Base

Why is "cdp enable" not showing in running-config on cisco switches after applying the RCF?

  1. Last updated
  2. Save as PDF
Views:
441
Visibility:
Public
Votes:
0
Category:
metrocluster
Specialty:
nas
Last Updated:

Applies to

  • MetroCluster over IP
  • Cluster Switches
  • Cisco
  • Reference configuration file (RCF)
  • Cisco Discovery Protocol (CDP)

Answer

  • The cdp enable setting is only visible in the running-config if it is globally disabled
  • To verify the CDP setting use the show cdp neighbors command instead

site-a-sw2# show cdp neighbors
Capability Codes: R - Router, T - Trans-Bridge, B - Source-Route-Bridge
                  S - Switch, H - Host, I - IGMP, r - Repeater,
                  V - VoIP-Phone, D - Remotely-Managed-Device, s - Supports-STP-Dispute
Device-ID          Local Intrfce  Hldtme Capability  Platform      Port ID
cbc-mgmt-sw-r01     mgmt0          138    S I       WS-C2960-24TT Fas0/22
cluster-a-01        Eth1/3         176    H         AFF-A800      e1a
cluster-a-02        Eth1/4         174    H         AFF-A800      e1a

Additional Information

For the diffrent version of nexus os use the cisco web site for more documentation on the commands

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.