NetApp mediator configuration fails with the following error: Adding the mediator and enabling Automatic Unplanned Switchover. Error: command failed: The request to reach the mediator failed during th...NetApp mediator configuration fails with the following error: Adding the mediator and enabling Automatic Unplanned Switchover. Error: command failed: The request to reach the mediator failed during the add operation. Check if the mediator is reachable and then try the operation again. Mediator log in the host machine shows the following errors:
Applies to Metrocluster over IP Cisco cluster switches Reference configuration file (RCF) Answer The no vlan dot1Q tag native setting from RCF is not visible in the show running-config Use the show vl...Applies to Metrocluster over IP Cisco cluster switches Reference configuration file (RCF) Answer The no vlan dot1Q tag native setting from RCF is not visible in the show running-config Use the show vlan dot1Q tag native command instead site-a-sw2# show vlan dot1Q tag native vlan dot1q native tag is disabled Additional Information For the diffrent version of nexus os use the cisco web site for more documentation on the commands
Cisco Discovery Protocol (CDP) The cdp enable setting is only visible in the running-config if it is globally disabled To verify the CDP setting use the show cdp neighbors command instead site-a-sw2# ...Cisco Discovery Protocol (CDP) The cdp enable setting is only visible in the running-config if it is globally disabled To verify the CDP setting use the show cdp neighbors command instead site-a-sw2# show cdp neighbors Capability Codes: R - Router, T - Trans-Bridge, B - Source-Route-Bridge S - Switch, H - Host, I - IGMP, r - Repeater, cbc-mgmt-sw-r01 mgmt0 138 S I WS-C2960-24TT Fas0/22 For the diffrent version of nexus os use the cisco web site for more documentation on the commands
