Skip to main content
NetApp Knowledge Base

25G ports not coming online after reset on BES-53248 switch

Last Updated:

Applies to

  • MetroCluster IP
  • BES-53248
  • Switch reboot 


When using 25G DACs in a SFP28 port, the speed must be set for that port. Reloading may not successfully apply the speed configuration for 25G speed DAC cables:

 Switch1# show port all

                 Admin     Physical   Physical   Link   Link    LACP   Actor
Intf      Type   Mode      Mode       Status     Status Trap    Mode   Timeout
--------- ------ --------- ---------- ---------- ------ ------- ------ --------
0/5              Enable    Auto                  Down   Enable  Enable long
0/6              Enable    Auto                  Down   Enable  Enable long



Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
Scan to view the article on your device