Skip to main content
NetApp Knowledge Base

What is the "disk.read_rate_life" option

  1. Last updated
  2. Save as PDF
Views:
151
Visibility:
Public
Votes:
0
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • FAS System
  • AFF System
  • SSD

Answer

  • By enabling "disk.read_rate_life" option system can read rated life values from SSD drive.
  • By default, the rated life values are read every 24 hours.
    • The error message for 100% used is output every 24 hours.
    • The error messages for 90% to 99% are output every 7 days. 

Additional Information

"disk.read_rate_life" option can be enable/disable with following command

::>system node run -node <node_name> -command options disk.read_rate_life.enable off
::>system node run -node <node_name> -command options disk.read_rate_life.enable on

 

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.