Skip to main content
NetApp Knowledge Base

Disk Firmware is not upgrading automatically due to manufacturing attribute set

Views:
4,062
Visibility:
Public
Votes:
3
Category:
fas-systems
Specialty:
hw
Last Updated:

Applies to

  • AFF systems
  • FAS systems
  • ONTAP 9
  • Automatic Disk Firmware update

Issue

Disk Firmware is not upgrading automatically when:
  • The firmware is properly downloaded on all nodes
  • The automatic upgrade option is on across all nodes

The following command shows the same output continuously (some disks pending download but the state is always idle):

::> set advanced
::*> storage disk firmware show-update-status
                             Number     Average      Total
                   Update   Waiting    Duration Completion
Node               State   Download /Disk (Sec) Est. (Min) Unable to Update
------------------ ------- -------- ----------- ---------- --------------------
Filer1             idle           1         120          2 -
Filer2             idle          23         120         46 -

 

 

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.
  • Was this article helpful?