Skip to main content
NetApp Knowledge Base

Cannot disable CIFS auditing

  1. Last updated
  2. Save as PDF
Views:
497
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
nas
Last Updated:

Applies to

  • ONTAP 9.x
  • CIFS auditing enabled

Issue

When attempting to disable CIFS auditing the command fails with the following error below:
 

::> vserver audit disable -vserver TheVserver
Error: command failed: Failed to disable auditing for Vserver "TheVserver". Reason: Audit consolidation job not present for the Vserver and one of the possible reasons might be snapmirror break operation in Vserver DR setup. Retry after some time.


::> vserver audit enable -vserver TheVserver
Error: command failed: Cannot enable auditing for Vserver "TheVserver". Reason: Auditing is already enabled for this Vserver.

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.