Skip to main content
NetApp Knowledge Base

Volume move fails with "volume is involved in a SnapMirror operation and cannot be moved," but no SnapMirror relationship is configured

  1. Last updated
  2. Save as PDF
Views:
2,746
Visibility:
Public
Votes:
2
Category:
snapmirror
Specialty:
dp
Last Updated:

​ ​

Applies to

ONTAP 9.0 (or later)

Issue

  • A volume move is attemped, but fails while setting up the move operation.  
  • When volume move show is run to determine the cause of the failure, Detailed Status indicates:

The volume is involved in a SnapMirror operation and cannot be moved until the SnapMirror operation is complete. Wait for the SnapMirror operation to finish or abort the SnapMirror operation by issuing a 'snapmirror abort -hard true' command.

  • As implied by Detailed Status, volume move can fail when there is an active SnapMirror relationship.
  • When snapmirror show is run, there is no SnapMirror relationship associated with the volume being moved. 
  • In addition to the absence of a SnapMirror relationship, SKTrace logs in /etc/log/mlog/sktrace.log may contain the message:SM_VM: Failed to fence volume
     

 

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.