Skip to main content
NetApp Knowledge Base

Service Processor status not visible on command line after upgrade

Views:
602
Visibility:
Public
Votes:
0
Category:
ontap-9
Specialty:
core
Last Updated:

Applies to

  • FAS2650
  • ONTAP version: 9.3P4
  • SP version: 5.6P1

Issue

After performing an SP (Service Processor) firmware upgrade to version 5.6P1, the SP status on one of the nodes might not be visible from the command line.

cluster::> system service-processor show
 IP Firmware
Node          Type    Status    Configured   Version    IP Address
------------- ---- ----------- ------------ --------- -------------------------
Node1          SP     online      true        5.6P1      128.1.50.171


Error: show failed: Database is not open.

Sign in to view the entire content of this KB article.

New to NetApp?

Learn more about our award-winning Support

NetApp provides no representations or warranties regarding the accuracy or reliability or serviceability of any information or recommendations provided in this publication or with respect to any results that may be obtained by the use of the information or observance of any recommendations provided herein. The information in this document is distributed AS IS and the use of this information or the implementation of any recommendations or techniques herein is a customer's responsibility and depends on the customer's ability to evaluate and integrate them into the customer's operational environment. This document and the information contained herein may be used solely in connection with the NetApp products discussed in this document.